Brother International PR670E Operation Manual - Page 225
Error messages
View all Brother International PR670E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 225 highlights
APPENDIX Error messages If the start/stop button is pressed while the machine is not correctly set up or if an incorrect operation is performed, the machine stops and informs you of the error with a buzzer and an error message. If an error message appears, correct the problem according to the instructions in the message. To close the message, touch or perform the correct operation, then touch appears again, consult your nearest authorized Brother dealer. . If the message Some malfunction occurred. There are too many characters in the curved text arrangement for the selected embroidery frame. Change the text arrangement or the embroidery frame. Machine cannot receive any data from the PC in the Link mode. Turn off the machine, and check the USB connection. After connect the USB cord securely, turn on the machine again. (Refer to page 142) The installed embroidery frame is too small. Check which embroidery frames can be used, and then install a larger embroidery frame. (Refer to page 42.) The upper thread broke, the thread came out of the thread tension disc or a thread guide, or the machine is not threaded correctly. Check that the thread passes under the upper and middle thread guides, and correctly thread the upper thread. (Refer to page 50.) If the thread is not broken, clean the thread guides and the tension unit. (Refer to page 213.) The bobbin thread broke or ran out. Check that there is thread on the bobbin and that approximately 50 mm (2 inches) of thread has been pulled out, and then re-install the bobbin. (Refer to page 33.) Lint or dust has accumulated in the thread tension disc. Remove the tension dials, and then remove any lint or dust accumulated between the felt washers. (Refer to page 213.) The thread tension is too tight. Check the tensions of the upper thread and bobbin thread, and then adjust them. (Refer to page 102.) The patterns you are editing take up too much memory, or you are editing too many patterns for the memory. * Since there may be many other causes, refer to the Troubleshooting table. The upper thread breaks. (Refer to page 219.) The bobbin thread breaks. (Refer to page 220.) * Touch to move the needle back or forward. (Refer to page 97.) 7 223