Brother International PR670E Operation Manual - Page 154
Rotating a pattern
View all Brother International PR670E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
Memo • In Stitch Recalculator mode, the pattern can be reduced/enlarged between 60% and 120%. • With the density scale bar, the thread density can be changed. A setting between 80% and 120% in 5% increments can be specified. Rotating a pattern The pattern can be rotated in either direction to the desired angle. Touch . a 1 2 1 Touch 2 Touch to make the pattern less dense. to make the pattern more dense. Touch . e The screen shown below appears. Note • Depending on the pattern, embroidering may not be possible at the appropriate thread density. Before sewing on your project, be sure to embroider a trial sample on a piece of scrap fabric that is the same as the fabric used in the project, using the same needle and embroidery thread. • If the pattern is enlarged and there is space between stitches, a better effect can be achieved by increasing the thread density. • If the pattern is reduced and the stitching is too thick, a better effect can be achieved by reducing the thread density. CAUTION • Depending on the pattern, the stitching may become entangled or the needle may break when the pattern is reduced. If this occurs, slightly enlarge the pattern. • After changing the size of the pattern, check the icons for the embroidery frames that can be used and use only the indicated frames. If a frame other than those indicated are used, the presser foot may hit the embroidery frame and cause injuries. • For details on each key, refer to "Adjusting the angle" on page 91. Touch the keys to adjust the pattern to the b desired angle. Each touch of a key rotates the pattern. 1 1 Shows the angle of the pattern after a key is touched to change it. • To return the pattern to its original angle, touch . If necessary, touch the arrow keys to adjust c the position of the pattern. (For more details, refer to page 148.) 152