Brother International PR670E Operation Manual - Page 120

Touch . Specifying pause locations before c embroidering Pause locations can be specified in the pause setting screen, displayed by touching . Touch a screen. in the embroidering settings  The mark appears to indicate where the machine will stop. 1  The change thread color screen appears. From the thread color sequence display, b select the thread color where you wish to stop the machine before sewing it. • If the desired thread color is not displayed, use the scroll bar on the right side to display it. 1 1 Scroll bar • If the same thread color is used more than once, they can be combined. After selecting a thread color, touch . The key changes to , and all thread colors in the thread color sequence display that are the same as the one that was selected are highlighted in blue. 1 mark • To cancel the setting, touch again. Repeat steps b and c for each pause that d you wish to specify. • Any number of pauses can be specified. After specifying the desired settings, touch e . • If the machine is temporarily turned off when it is stopped at the specified location after embroidering, you will be asked if you wish to continue sewing or select a new pattern when the machine is turned on again. Touch to continue embroidering. (Refer to "Resume Embroidering After Turning Off the Machine" on page 101.) Memo • If the machine is temporarily turned off, the settings to stop the machine at color changes specified before the machine was turned off are not cancelled. However, the settings are cancelled if a new pattern is selected. • If a pattern with the settings to stop the machine at color changes is saved, the settings to stop the machine at color changes are also saved. 118