Brother International PR670E Operation Manual - Page 211
If bobbin winding is stopped before, it is finished
View all Brother International PR670E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Remove the bobbin. k APPENDIX ■ If bobbin winding is stopped before it is finished: The bobbin winder stops automatically if the thread does not feed, for example, if it becomes tangled on the spool pin. If this occurs, correctly thread the bobbin winder, and then wind the bobbin correctly. Note • When removing the bobbin, do not pull on the bobbin winder seat. Doing so could loosen or remove the bobbin winder seat, resulting in damage to the bobbin winder. Pull the thread through the guide slit in the l bobbin winder seat to cut the thread with the cutter. CAUTION • Check that the bobbin thread has been wound correctly, otherwise the needle may break or the thread tension will be incorrect. • Be sure to clean the bobbin case each time that the bobbin is changed. Thread wax and dust easily collect around the hole in the tension-adjusting spring on the bobbin case, resulting in an incorrect thread tension. For details, refer to "Cleaning the bobbin case" on page 212. • Be sure to check the tension of the bobbin thread each time that the bobbin is changed. • Depending on the bobbin thread type, the tension of the bobbin thread may differ. Be sure to check the tension of the bobbin thread and adjust the tension if necessary. For a metal bobbin, use both weights, large (L) and small (S). For detailed instructions on how to adjust the bobbin tension, refer to page 102. 7 1 Weight (L) (Part Code: XC5974-151) 2 Weight (S) (Part Code: XC6631-051) 209