Brother International PR670E Operation Manual - Page 92

Memo • If the LED pointer is set to "ON", it shows you the needle drop point. Note • The LED pointer may not be available depending on the type of embroidery frame attached. • With fabric that has a very uneven or textured surface, the position of the LED pointer may not be correctly aligned. In this case, the pointer indication should be used only as a reference. ■ Finding the sewing position By locking the needle bar (securing the needle and presser foot in the down position), the needle drop point can easily be seen. As shown in the illustration, insert the Allen a screwdriver into the hole in the needle clamp to slowly lower the needle bar down till needle bar stops then clicks into the lock position. Note • Make sure that the needle is not lowered beyond the positioning click into the fabric. 1 2 1 Shows the vertical distance moved from center 2 Shows the horizontal distance moved from center • Touch to move the embroidery frame back to its original position (where the center of the embroidery frame is aligned with the needle drop point at the sewing position).  The needle and presser foot are locked in the down position. Touch the arrow keys in the embroidering b settings screen to move the embroidery frame so that the needle drop point is at the center of the area where you wish to embroider. • With a USB mouse, your finger or the touch pen, drag the pattern to move it. The pattern can also be moved by dragging it. If a USB mouse is connected, move the mouse to position the pointer on the desired pattern, and then while holding in the left mouse button, drag the pattern. The pattern can also be dragged by selecting it directly in the screen with your finger or the touch pen. • When specifying the starting of stitching, align the needle drop point with the point specified as the starting of stitching. (For details on specifying the starting/ending of stitching, refer to page 113.) 90