Dell Broadcom NetXtreme Family of Adapters Broadcom NetXtreme II Network Adapt - Page 120

Broadcom Teaming Services: Broadcom NetXtreme II Network Adapter User Guide usage. 2 Error Failed to allocate map registers. The driver cannot allocate map registers from the operating system. Unload other drivers that may allocate map registers. 3 Error Failed to access configuration information. Reinstall the network driver. The driver cannot access PCI configuration space registers on the adapter. For add-in adapters: reseat the adapter in the slot, move the adapter to another PCI slot, or replace the adapter. 4 Warning The network link is down. Check to make sure the network cable is properly connected. The adapter has lost its connection with its link partner. Check that the network cable is connected, verify that the network cable is the right type, and verify that the link partner (for example, switch or hub) is working correctly. 5 Informational The up. network link is The adapter has established a link. No action is required. 6 Network controller Informational configured for 10Mb half-duplex link. The adapter has been manually configured for the selected line speed and duplex settings. No action is required. 7 Network controller Informational configured for 10Mb full-duplex link. The adapter has been manually configured for the selected line speed and duplex settings. No action is required. 8 Network controller Informational configured for 100Mb half-duplex link. The adapter has been manually configured for the selected line speed and duplex settings. No action is required. 9 Network controller Informational configured for 100Mb full-duplex link. The adapter has been manually configured for the selected line speed and duplex settings. No action is required. 10 Network controller Informational configured for 1Gb half-duplex link. The adapter has been manually configured for the selected line speed and duplex settings. No action is required. 11 Network controller Informational configured for 1Gb full-duplex link. The adapter has been manually configured for the selected line speed and duplex settings. No action is required. 12 Network controller Informational configured for 2.5Gb full-duplex link. The adapter has been manually configured for the selected line speed and duplex settings. No action is required. 13 Error Medium not supported. The operating system does not support the IEEE 802.3 medium. Reboot the operating system, run a virus check, run a disk check (chkdsk), and reinstall the operating system. 14 Error Unable to register the interrupt service routine. The device driver cannot install the interrupt handler. Reboot the operating system; remove other device drivers that may be sharing the same IRQ. 15 Error Unable to map IO space. The device driver cannot Remove other adapters from the system, allocate memory-mapped I/O reduce the amount of physical memory to access driver registers. installed, and replace the adapter. 16 Informational Driver initialized successfully. The driver has successfully loaded. No action is required. 17 Informational NDIS is resetting miniport driver. the The NDIS layer has detected a problem sending/receiving packets and is resetting the driver to resolve the problem. Run Broadcom Advanced Control Suite diagnostics; check that the network cable is good. 18 Error Unknown PHY detected. Using a default PHY initialization routine. The driver could not read the PHY ID. Replace the adapter. file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/teamsvcs.htm[9/26/2012 3:29:14 PM]