Dell Broadcom NetXtreme Family of Adapters Broadcom NetXtreme II Network Adapt - Page 46
RxTicks, TxPacketsPer, CheckSum, FlowCtrl, PDriver
View all Dell Broadcom NetXtreme Family of Adapters manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
NetWare Driver Software: Broadcom NetXtreme II Network Adapter User Guide RxTicks= Enables the use of batching receives within a specific time period. Min = 0 (Disabled) Max = 5000000 (5 seconds) Units are in microseconds, The default value is 300. TxTicks= Enables the use of a transmit tick threshold interrupt within a specific time period. Min = 0 (Disabled) Max = 5000000 (5 seconds) Units are in microseconds. The default value is 200. TxPacketsPer= Enables allowing an interrupt to occur after a specific amount of packets is transmitted. Min = 0 (Disabled) Max = 100 The default value is 20. RxPacketsPer= Enables allowing an interrupt to occur after a specific amount of packets is received. Min = 0 (Disabled) Max = 100 The default value is 75. CheckSum= Enables or disables the transmit and receive checksum offload feature. Checksum offload support is only for TCP/IP packets; therefore, the default setting for checksum offload is OFF. OFF ON TX RX FlowCtrl= This keyword allows enabling/disabling of transmit and receive flow control. BOTH RX TX OFF The default setting is OFF. PDriver= Enables the driver to operate in persistent driver mode. Use only if the adapter is placed in a hot-plug slot and only if you must swap with an adapter that is exactly the same. OFF ON file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/netware.htm[9/26/2012 3:28:49 PM]