Dell Broadcom NetXtreme Family of Adapters Broadcom NetXtreme II Network Adapt - Page 39
BNX2I Driver signon, Link Down Indication
View all Dell Broadcom NetXtreme Family of Adapters manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Linux Driver Software: Broadcom NetXtreme II Network Adapter User Guide bnx2: eth# NIC Link is Up, 1000 Mbps full duplex Link Down Indication bnx2: eth# NIC Link is Down MSI enabled successfully (bnx2 only) bnx2: eth0: using MSI MSI-X enabled successfully (bnx2x only) bnx2x: eth0: using MSI-X bnx2i Driver BNX2I Driver signon Broadcom NetXtreme II iSCSI Driver bnx2i v2.1.1D (May 12, 2010) Network port to iSCSI transport name binding bnx2i: netif=eth2, iscsi=bcm570x-050000 bnx2i: netif=eth1, iscsi=bcm570x-030c00 Driver completes handshake with iSCSI offload-enabled CNIC device bnx2i [05:00.00]: ISCSI_INIT passed NOTE: This message is displayed only when the user attempts to make an iSCSI connection. Driver detects iSCSI offload is not enabled on the CNIC device bnx2i: iSCSI not supported, dev=eth3 bnx2i: bnx2i: LOM is not enabled to offload iSCSI connections, dev=eth0 bnx2i: dev eth0 does not support iSCSI Exceeds maximum allowed iSCSI connection offload limit bnx2i: alloc_ep: unable to allocate iscsi cid bnx2i: unable to allocate iSCSI context resources Network route to target node and transport name binding are two different devices bnx2i: conn bind, ep=0x... ($ROUTE_HBA) does not belong to hba $USER_CHOSEN_HBA where ROUTE_HBA --> net device on which connection was offloaded based on route information USER_CHOSEN_HBA --> HBA to which target node is bound (using iscsi transport name) Target cannot be reached on any of the CNIC devices bnx2i: check route, cannot connect using cnic Network route is assigned to network interface, which is down bnx2i: check route, hba not found Attempting to offload iSCSI connection onto a Jumbo Frame-enabled device bnx2i: eth# network i/f mtu is set to #mtu bnx2i: iSCSI HBA can support mtu of 1500 NOTE: Change mtu to 1500 using ifconfig and restart the interface in order to offload iSCSI connections. SCSI-ML initiated host reset (session recovery) bnx2i: attempting to reset host, #3 CNIC detects iSCSI protocol violation - Fatal errors bnx2i: iscsi_error - wrong StatSN rcvd bnx2i: iscsi_error - hdr digest err bnx2i: iscsi_error - data digest err bnx2i: iscsi_error - wrong opcode rcvd bnx2i: iscsi_error - AHS len > 0 rcvd bnx2i: iscsi_error - invalid ITT rcvd bnx2i: iscsi_error - wrong StatSN rcvd bnx2i: iscsi_error - wrong DataSN rcvd bnx2i: iscsi_error - pend R2T violation file:///T|/htdocs/NETWORK/BroadCom/71921/NetXtremeII/en/linux.htm[9/26/2012 3:28:46 PM]