Dell DX6000G Hardware Owner's Manual - Page 44
Quad rank DIMM, Plug & Play
View all Dell DX6000G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Table 1-2. System Messages (continued) Message Causes Corrective Actions Plug & Play Configuration Error Error encountered in initializing PCIe device; faulty system board. Install the NVRAM_CLR jumper in the clear position (pins 1 and 3) and reboot the system. See Figure 6-1 for jumper location. If the problem persists, see "Troubleshooting Expansion Cards" on page 155. Quad rank DIMM Invalid memory detected after configuration. single rank or dual rank DIMM in socket. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 111. Read fault Requested sector not found The operating system cannot Replace the optical medium, read from the hard drive, USB medium, or USB optical drive, or USB device, device. Ensure that the USB the system could not find a cables, SAS/SATA backplane particular sector on the disk, cables, or optical drive cables or the requested sector is are properly connected. defective. See "Troubleshooting a USB Device" on page 142, "Troubleshooting an Optical Drive" on page 151, or "Troubleshooting a Hard Drive" on page 152 for the appropriate drive(s) installed in your system. SATA Port x device not found There is no device connected Information only. to the specified SATA port. 44 About Your System