Dell DX6000G Hardware Owner's Manual - Page 45
See Getting Help on, Sparing mode. See System
View all Dell DX6000G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Table 1-2. System Messages (continued) Message Causes Corrective Actions Sector not found Seek error Seek operation failed Faulty hard drive, USB device, or USB medium. Replace the USB medium or device. Ensure that the USB or SAS backplane cables are properly connected. See "Troubleshooting a USB Device" on page 142 or "Troubleshooting a Hard Drive" on page 152 for the appropriate drive(s) installed in your system. Shutdown failure General system error. See "Getting Help" on page 169. Sparing mode disabled. For sparing mode, matched sets of three must be populated across slots. The memory configuration Reconfigure the memory does not match the setting in modules for Memory BIOS. The BIOS setting has Sparing mode. See "System been disabled. Memory" on page 110. The amount of Memory has been added or system memory has removed or a memory changed module may be faulty. If memory has been added or removed, this message is informative and can be ignored. If memory has not been added or removed, check the SEL to determine if single-bit or multi-bit errors were detected and replace the faulty memory module. See "Troubleshooting System Memory" on page 148. About Your System 45