Dell PowerEdge 1955 Hardware Owner's Manual (PDF) - Page 38
Reseat the daughter card. See I/O, Module Daughter Card on If - hard drive
View all Dell PowerEdge 1955 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Table 1-13. Server Module Messages (continued) Message Causes Corrective Actions Memory address line failure at address, read value expecting value Memory double word logic failure at address, read value expecting value Faulty or improperly installed memory Ensure that all memory modules are modules, or faulty server module properly installed. See "Troubleshooting board. Server Module Memory" on page 112. If the problem persists, see "Getting Help" on page 127. Memory odd/even logic failure at start address to end address Memory write/read failure at address, read value expecting value Memory mirroring enabled Memory mirroring enabled Information only. Memory tests terminated by The spacebar was pressed during Information only. keystroke POST to terminate the memory test. No boot device available Faulty or missing diskette drive, optical drive, or hard drive. Check the Integrated Devices configuration settings in the System Setup program and ensure that the controller for the boot device is enabled. See "Using the System Setup Program" on page 43. Ensure that the controller for the boot device is enabled. If the problem persists, replace the drive. See "Hard Drives" on page 89. No boot sector on hard-disk drive An operating system is not on the hard drive. Check the hard-drive configuration settings in the System Setup program. See "Using the System Setup Program" on page 43. No timer tick interrupt Faulty server module board. See "Getting Help" on page 127. Not a boot diskette Not a bootable diskette. Use a bootable diskette. PCI BIOS failed to install Faulty or improperly installed. Reseat the daughter card. See "I/O Module Daughter Card" on page 82. If the problem persists, see "Getting Help" on page 127. 38 About Your System