Dell PowerEdge 1955 Hardware Owner's Manual (PDF) - Page 93
Installing the Back-Panel Module Cage Assembly
View all Dell PowerEdge 1955 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
6 Remove the KVM module. See "Removing a KVM Module" on page 63. 7 Remove the I/O modules. See "Removing an I/O Module" on page 71. 8 Remove the four screws securing the module cage assembly to the chassis back panel. See Figure 3-23. 9 Pull the assembly out of the chassis approximately half way until it stops, press the two side levers on the sides of the cage, and then pull the cage out from the chassis. See Figure 3-23. Figure 3-23. Removing and Installing the Back-Panel Module Cage Assembly 1 2 5 3 4 1 module cage assembly 4 back rails (2) 2 chassis 5 screws (4) 3 side levers (2) Installing the Back-Panel Module Cage Assembly CAUTION: Only trained service technicians are authorized to remove the system cover and access any of the components inside the system. See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting against electrostatic discharge. 1 Insert the module-cage assembly into the back of the chassis and push the assembly in until the back rails are flush against the chassis back panel. See Figure 3-23. 2 Install the four screws to secure the module cage assembly to the chassis back panel. 3 Install the I/O modules. See "Installing an I/O Module" on page 72. 4 Install the KVM module. See "Installing a KVM Module" on page 63. 5 Install the DRAC/MC module. See "Installing a DRAC/MC Module" on page 62. Installing System Options 93