Dell PowerEdge 1955 Hardware Owner's Manual (PDF) - Page 97
Installing the Server Module Control Panel,
View all Dell PowerEdge 1955 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
Figure 3-25. Removing and Installing the Server Module Control Panel Assembly 1 2 7 6 5 4 3 1 screws (2) 4 server module-board connector 7 control panel 2 control panel cable retaining 3 retaining clip clip 5 control panel cable 6 top bracket Installing the Server Module Control Panel 1 Place the new control panel under the server module top bracket and secure it with the two screws. See Figure 3-25. 2 Route the control-panel cable under its retaining clip. 3 Connect the control-panel cable to the server module-board connector: a Pull up the retaining clip on top of the connector. b Slip the cable between the retaining clip and the connector and press down on the clip to secure the cable. NOTE: The cable attaches to the connector on the control panel in the same manner. 4 Close the server module. See "Closing the Server Module" on page 76. 5 Install the server module. See "Installing a Server Module" on page 74. Installing System Options 97