Epson C3500 Technical Reference Guide - Page 212

Media type Media source Backing paper width Label width Label length Gap between labels Left and right outer edges Edge cutoff width Label edge R Width of a black mark Length of a black mark Center of a black mark Gaps between black marks Paper thickness Perforated line pitch Form of perforated line Number of folds Plain label / Matte label Fanfold paper 50 to 112 mm {1.97 to 4.41"} 46 to 108 mm {1.81 to 4.25"} 8 to 301.8 mm {0.32 to 11.88"} 3 to 6 mm {0.12 to 0.24"} 2 mm  0.5 mm {0.079  0.02"} 1.5 mm or more 1.5 mm {0.059"} or less 13 mm {0.51"} or more 4 mm {0.16"} or more (with a width of at least 4 mm around) 8.5 mm  1 mm {0.33  0.039"} 11 to 304.8 mm {0.43 to 12.0"} 0.161 to 0.164 mm {0.0063 to 0.0065"} 203.2 to 304.8 mm {8 to 12"} Plain media : 1 mm {0.039"} uncut, 5 mm {0.2"} cut Fine media : 1 mm {0.039"} uncut, 5 mm {0.2"} cut PET film : 0.6 mm uncut, 8.4 mm cut 500 or less  Do not use the paper with a hole or cutout.  Autocutting on the perforated lines may generate minute paper dust, causing machine problems. Also, autocutting ahead of the perforated line may cause problems when feeding paper. Therefore, autocutting must be performed 0.5 mm to 1 mm {0.02 to 0.039"} behind the perforated line.  When using fanfold paper, the black marks must be at least 2 mm {0.079"} from the perforated lines.  As for the black mark position on the die-cut label paper, match the label edge and the black mark edge.  The perforated lines on both sides of the paper edge must be left uncut.  You can use paper with all fringes removed or paper with fringes on the left and right removed.  By setting the black marks on both sides, you can insert paper from either side. 212