Epson NX User Manual - Page 76
Replacing the System Board, Removing the Front Bezel,
View all Epson NX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Removing and Replacing Subassemblies Replacing the System Board Follow these steps to replace the system board: 1 From the left side of the chassis, insert the system board into the chassis at a slight angle. 2 Slide the far edge of the system board under the drive bay. 3 Lower the board into the chassis and position the six screw holes over the mounting holes in the chassis. 4 Secure the board with the six retaining screws (see Figure 3-17). 5 Reinstall the option card riser board (see page 3-8) and replace any option cards (see page 3-7). 6 Reconnect all cables and replace the cover. Removing the Front Bezel Follow these steps to remove the front bezel: 1 Remove the cover (see page 3-2). 2 Remove the two retaining screws located on the back side of the bezel as shown in Figure 3-18. Figure 3-18 Removing/Replacing the Front Bezel 3 Set the cover upside down on a smooth flat surface and locating the front bezel locking tabs gently press down on the tabs while pulling the bezel away from the cover. Epson NX Service Manual 3-23