Fujitsu 5900C Operator's Guide - Page 154
Hardware Alarms - e18
UPC - 097564306945
View all Fujitsu 5900C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
■ Hardware Alarms [E] and a number will be displayed alternately. Display Meaning E0 Error in the Hopper or Stacker E2 Optical system error (front) E3 Optical system error (back) E4 The motor fuse has blown out. E5 The lamp fuse has blown out. E6 Operator panel error E7 Trouble occurred in the internal memory (EEPROM). E8 The SCSI fuse has blown out. E9 Image memory error EA Imprinter error Ec Image memory error Ed SCSI interface or USB interface controller error EF Background switching mechanism error E10 ROM error E11 Cooling fan error E12 Heater error E15 Extended memory error E16 Option board error E17 The imprinter fuse has blown out. E18 Sensor error E19 LSI error E1A Troubles occurred in the communication inside of the scanner. Solution When you encounter any alarm, turn off and on the scanner. If the alarm is still displayed on the Function Number Display, contact the dealer where you purchased the scanner or an authorized FUJITSU scanner service provider. Confirm the following: 1. Is the used additional memory compatible? 2. Is the additional memory installed correctly? 3. Is the additional memory damaged? Note that this error will be displayed only three times after powering the scanner on. After that, the scanner will perform scanning in the state of no additional memory installed. When you encounter this E15 error, turn off and on the scanner. If the alarm is still displayed on the Function Number Display, contact the dealer where you purchased the scanner or an autho-rized FUJITSU scanner service provider. When you encounter any alarm, turn off and on the scanner. If the alarm is still displayed on the Function Number Display, contact the dealer where you purchased the scanner or an authorized FUJITSU scanner service provider. 134 6.2 Error messages of the Operator panel