Fujitsu 5900C Operator's Guide - Page 50

2.10 Scanning Documents When scanning documents, normally you need to run the scanner driver using the application software. The following shows the procedure for scanning documents using the "ScandAll 21" application (simply called "ScandAll 21" from now on.) The procedure differs depending on application being used. When you use an application other than ScandAll 21, refer to the manual attached to the application. 1. Load the documents on the hopper. Refer to the section "2.6 Loading Documents on the Hopper" on page 17 2. Adjust the stacker table to the document size. ATTENTION • When loading long documents on the hopper, extend the stacker extension. • When loading short documents on the hopper, adjust the stacker length with the small stopper. 3. Start up ScandAll 21. From the [Start] menu, select [Program] - [Scanner Utility for Microsoft Windows] - [ScandAll 21]. This starts up ScandAll 21. 4. Select the scanner to use. Select [Select Source] from the [Scan] menu. The [Select source] dialog box appears. Select [FUJITSU Fi-5900Cd] (for TWAIN32 V8, [FUJITSU TWAIN32]). Then click [Select]. 30 2.10 Scanning Documents