Fujitsu 5900C Operator's Guide - Page 190
Scanner Settings, SCSI Bus Width
UPC - 097564306945
View all Fujitsu 5900C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 190 highlights
Page edge filler (Automatic paper size detection) Fill the end sections of a specifiedmm-wide with white when the paper size is automatically detected. The end sections of a specifiedmm-wide are filled with white. Top/Left/Right/Bottom: 0 to 7.5mm (can be set in increments of 0.5mm) A Top/Bottom/ Left/Right: 0mm B (A: Image area B: Filled area A+B: Area to be output) Document check area specification for Multifeed Detection Specify the area to be detected for Left/Middle/Right multifeed. You can select left, middle, or right for detection. Refer to "8.4 Multifeed Detection" on page 175. - Modes of selec- Specify which area to check for Non-detection area/Detection area tion multifeed: The area for which mul- tifeed detection is enabled or the area for which multifeed detection is disabled. Refer to "8.4 Multifeed Detec- tion" on page 175. - Specify area Specify the range where multifeed detection is enabled/disabled. Refer to "8.4 Multifeed Detection" on page 175. Start: 0 - 550mm End: 0 - 550mm Thin Paper Mode To scan thin paper documents, enable this mode. Disable/enable Paper Jam Detection Specify the degree of jam detection Normal/Sensitivity low at the feeder. AutoCrop Bound- Select Round Up or Round Down: Round Up/Round Down ary The fractional figures can be rounded up or down when the paper size is automatically detected. SCSI Bus Width Specify the data transfer width for 16-bit (wide)/8-bit SCSI connection. Auto Color Detection Specify the slice level for automati- 0 to 255 (steps) cally detecting Color/Monochrome Prepick To give a higher priority to process- Yes/No ing speed, select [Yes], if not, select [No]. Left Start/End: 0mm Disable Sensitivity-Low Round Down 16-bit 5 Yes 170 8.1 Scanner Settings