Fujitsu 5900C Operator's Guide - Page 37
Loading Documents on the Hopper, Preparing the Document - page edge
UPC - 097564306945
View all Fujitsu 5900C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
2.6 Loading Documents on the Hopper ■ Preparing the Document 1. Align both edges of the documents. For how to scan the document with different widths, refer to "3.3 Scanning HINT Documents with different widths" on page 73. 2 2. Fan the documents. 1) Take a stack of documents about 15mm to 20mm thick (1/2 to 3/4 inch). 2) Hold both ends and bend the documents into an arch. 15 to 20mm BASIC SCANNER OPERATIONS 3) Firmly holding the document with both hands, bend back the document as follows so that the bent section rises up in the middle of the document as follows. 4) Repeat steps 1) to 3) for a few times. 5) Rotate the document 90 degrees, and fan again. 3. Align the leading edges of the documents. 2.6 Loading Documents on the Hopper 17
17
2.6 Loading Documents on the Hopper
2
BASIC SCANNER OPERATIONS
2.6
Loading Documents on the Hopper
■
Preparing the Document
1.
Align both edges of the documents.
2.
Fan the documents.
1)
Take a stack of documents about 15mm to 20mm thick (1/2 to 3/4 inch).
2)
Hold both ends and bend the documents into an arch.
3)
Firmly holding the document with both hands, bend back the document as follows
so that the bent section rises up in the middle of the document as follows.
4)
Repeat steps 1) to 3) for a few times.
5)
Rotate the document 90 degrees, and fan again.
3.
Align the leading edges of the documents.
HINT
For how to scan the document with different widths, refer to
“3.3 Scanning
Documents with different widths” on page 73.
15 to 20mm