Fujitsu 6670 Operator's Guide - Page 175
Configuring the Data Transfer Width [SCSI Bus Width]
UPC - 097564307454
View all Fujitsu 6670 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
Chapter 9 Operational Settings Configuring the Data Transfer Width [SCSI Bus Width] You can configure the width of data transfer when your computer is connected to the scanner via SCSI Connector 2 on the CGA Board. 1 Start up the Software Operation Panel. Refer to "9.1 Starting Up the Software Operation Panel" (on page 156). 2 From the tree listing on the left, select [Device Setting 2] D [SCSI Bus Width]. Scan Setting for Documents with Tabs or NonRectangular Documents [Scan Setting for Documents with Tab (Automatic Paper Size Detection)] When configuring settings to scan a non-rectangular document with a tab (index) or tab (index) sticker at the its bottom, you can scan and include such a tab or tab sticker in the scanned image when [Automatic Paper Size Detection] is selected. 1 Start up the Software Operation Panel. Refer to "9.1 Starting Up the Software Operation Panel" (on page 156). 2 From the tree listing on the left, select [Device Setting 2] D [Scan Setting for Documents with Tab (Automatic Paper Size Detection)]. TOP Contents Index Introduction Scanner Overview Loading Documents How to Use ScandAll PRO Scan Parameters Various Documents Daily Care 3 Select [16 bit(Wide)] or [8 bit]. ʂ Select [8 bit] if using any SCSI card or SCSI cable that does not support Ultra Wide SCSI. Consumables Troubleshooting Operational Settings Appendix Glossary 175