Gateway NV-53A Service Guide - Page 50

CHAPTER 3: Replacing notebook components Preventing static electricity discharge Warning To avoid exposure to dangerous electrical voltages and moving parts, turn off your notebook, remove the battery, and unplug the power cord and network cable before opening the case. Warning To prevent risk of electric shock, do not insert any object into the vent holes of the notebook. Important Before performing maintenance on the notebook, you should read and understand the information in this section. The components inside your notebook are extremely sensitive to static electricity, also known as electrostatic discharge (ESD). Before performing maintenance on the notebook, follow these guidelines: • Avoid static-causing surfaces such as carpeted floors, plastic, and packing foam. • Remove components from their antistatic bags only when you are ready to use them. Do not lay components on the outside of antistatic bags because only the inside of the bags provide electrostatic protection. • Always hold components by their edges. Avoid touching the edge connectors. Never slide components over any surface. • Wear a grounding wrist strap (available at most electronics stores) and attach it to a bare metal part of your workbench or other grounded connection. • Touch a bare metal surface on your workbench or other grounded object. Tape Some of the procedures in this guide involve removing tape that secures cables or components. Two types of tape are used in this notebook: • Mylar, non-conductive tape is typically transparent, with a red or brown tint. • Conductive tape is typically grey or silver in color. If the existing tape cannot be reused, replace it with the same type. Make sure the replacement tape is of the non-ESD generating kind. Do not use cellophane tape. 44