HP 5200tn HP LaserJet 5200 Series Printer - Software Technical Reference (Exte - Page 346
Remote firmware update by using FTP on a direct network connection, Processing Job - lj
UPC - 882780123762
View all HP 5200tn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 346 highlights
Engineering Details NOTE The device automatically turns off and then on again to activate the update; this can happen more than once. At the end of the update process, the READY message appears on the control panel. Do not turn off the device or interfere with the update until you see this message. 7. Print a configuration page and verify that the firmware revision number matches the revision of the current update. Remote firmware update by using FTP on a direct network connection If the HP LaserJet 5200 uses a direct network connection, use file transfer protocol (FTP) to update the firmware. Complete the following steps: 1. Make note of the TCP/IP address on the Embedded Jetdirect page. The HP Embedded Jetdirect page is the second page of the configuration page printout. To print a configuration page, see Determining the current level of firmware NOTE Before connecting to the device, make sure that the device is not in Powersave mode. Also make sure that any error messages are cleared from the control-panel display. 2. Open a command window on the computer. 3. Type ftp . For example, if the TCP/IP address is 192.168.0.90, type ftp 192.168.0.90. 4. Press Enter on the keyboard. 5. When prompted for the user name, press Enter. 6. When prompted for the password, press Enter. 7. Type bin at the command prompt. 8. Press Enter. The message 200 Type set to I, Using binary mode to transfer files appears in the command window. 9. Type put , where is the name of the .RFU file that was downloaded from the Web, including the path. For example, type put C:\LJ\5200FW.RFU, and then press Enter. NOTE If the file name or path includes a space, you must enclose the file name or path in quotation marks. For example, type the following path: put "c:\My Documents\LJ\5200fw.rfu" The following series of messages appears in the command window: 200 PORT command successful 150 Opening BINARY mode data connection 226 Ready 226 Processing Job 226 Transfer complete 324 Chapter 7 Engineering Details ENWW