HP Scitex FB10000 Site Preparation Guide Rev. 2 - Page 28

General HP representatives supervise the unloading, unpacking, transfer and placement of the printer at its final destination, and the final installation process. To ensure proper installation, all procedures contained herein, unless otherwise specified, must be performed prior to the arrival of the main shipment at the customer's site. Do not unload and/or unpack the system without presence of an HP-authorized representative. Planning the Print Production Area Table 4-1 describes factors that should be taken into consideration when planning the print production area. Table 4-1 Print Production Area Requirement Value Doorway dimensions to print production area Minimum: 2.4 m (8 ft.) wide x 2.5 m (8.2 ft.) high Recommended: 3 m (10 ft.) wide x 2.5 m (8.2 ft.) high Minimum space surrounding FB10000 1.5 m (4.9 ft.) on all sides Minimum ceiling height 3.5 m (11.5 ft.) • Substrates can be extremely heavy and bulky. Therefore, it is important to provide unrestricted access and room for easy maneuverability within the print production area for loading and unloading them. • Provision of suitable emergency exits, to which unimpaired access may be maintained at all times, is imperative. • You should consider allocating additional floor space for operators, ink fill area, service area, maintenance area and for handling prints. For a sample floor plan of the FB10000 press and its external components (the drawings are to scale), see FB10000 Layout on page 78. 20 HP Scitex FB10000 Site Preparation Guide, Rev. 2