HP Scitex FB10000 Site Preparation Guide Rev. 2 - Page 43
Connecting the Mains, Electrical Cabinet
View all HP Scitex FB10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Connecting the Mains There are two options for connecting the mains power cable to the LEC (Left Electrical Cabinet): • Option 1 - The cable is routed under the machine frame, up through the left side of the IDS cabinet, and into the LEC via the side inlet. Approximately 2 m (6.6 ft.) of cable is required to route the cable inside the IDS cabinet. • Option 2 - The cable is routed to the LEC through an inlet at the top of the IDS cabinet. Approximately 1 m (3.3 ft.) of cable is required to route the cable through the top of the IDS cabinet. Top inlet Side inlet Mains power connection Figure 4-9 Mains Power Connection Options Chapter 4 - Site Planning 35
Chapter 4 - Site Planning
35
Connecting the Mains
There are two options for connecting the mains power cable to the LEC (Left
Electrical Cabinet):
•
Option 1
— The cable is routed under the machine frame, up through the left side
of the IDS cabinet, and into the LEC via the side inlet. Approximately 2 m (6.6 ft.)
of cable is required to route the cable inside the IDS cabinet.
•
Option 2
— The cable is routed to the LEC through an inlet at the top of the IDS
cabinet. Approximately 1 m (3.3 ft.) of cable is required to route the cable through
the top of the IDS cabinet.
Figure 4-9
Mains Power Connection Options
Mains power
connection
Side inlet
Top inlet