HP Scitex FB10000 Site Preparation Guide Rev. 2 - Page 49

Storage Area for Consumables and Substrates When planning the storage area for materials used with the HP Scitex FB10000 Industrial Press, in addition to safety and convenience considerations, you should take into account that if inks and substrates are not stored in the appropriate temperature and humidity conditions, print output results and machine reliability may be adversely affected. The storage area should be of sufficient size to accommodate adequate stocks of substrates and inks. Ideally, the storage area should be located reasonably close to the print production area, to avoid any unnecessary lifting and maneuvering of heavy materials. In addition to size and location, further considerations for the material storage area are that it should have a covered roof, be dry, well ventilated and able to provide protection from ultraviolet rays (a dark room is recommended). It is important that the temperature and humidity be maintained within the recommended values shown in Temperature and Humidity on page 40. One of the most important aspects of material storage is the potential fire hazard (see Fire Hazard on page 16 and Explosion Hazard on page 17) particularly with regard to inks and solvents. Containers must be properly sealed and stored in the upright position. It is strongly recommended that they be placed in a flameproof storage cabinet, fitted with a heat activated extinguishing device. Handling Substrates It is recommended that substrates remain in their sealed wrapping material when placed in storage. Figure 4-13 Substrates Wrapped in Sealing Material It is advisable to move them from the storage area to the print production area at least 24 hours before use, so that they can reach the required operating temperature. The general rule is 24 hours for every 10°C of difference in temperature. Chapter 4 - Site Planning 41