HP Scitex FB10000 Site Preparation Guide Rev. 2 - Page 65
Lift Release Handle, the lift is installed inside a pit.
View all HP Scitex FB10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
It is the customer's responsibility to prepare the exit hole for the unloader lift power cable. The hole can be of any shape as long as it allows the cable to pass freely from the pit to the rear cable channel on the FB10000. Exit hole Unloader pit Figure 4-25 Exit Hole for Unloader Lift Power Cable Lift Release Handle The unloader lift comes equipped from the manufacturer with a mechanical handle, which can be used to lower the lift safely when the FB10000 is powered down. This handle, however, is located at the base of the unloader lift and is inaccessible when the lift is installed inside a pit. For presses that are installed inside a pit, the unloader lift is equipped with a special lift release handle that is mounted on the frame of the unloader. The handle enables the operator to lower the lift safely and easily from a fully upright position. Figure 4-26 Lift Release Handle Chapter 4 - Site Planning 57