HP d640 HP D640 High-Volume Printer - Installation Manual (Printer and Accesso - Page 108
HP-UX Host Configuration, MPE/ix Host Configuration
View all HP d640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Printer Interfaces HP-UX Host Configuration • Network via JetDirect EX and JetAdmin for HP-UX • Direct Connect Parallel • Other host systems This chapter describes the following procedures: • Procedure 1: Install the Interface Cable, on page 3-10 • Procedure 2: Configure the Printer on Your Host System, on page 3-11 • Procedure 3: Setting the Printer's Communication Interface, on page 3-21 • Procedure 4: Confirm the Connection, on page 3-26 MPE/ix Host Configuration • MPE/iX 5.0 and below Get network printing software from third party vendors. Be sure to acquire a BOOTP program (or its equivalent) so you can load the IP address into the JetDirect EX. • MPE/iX 5.5 and after supports network printers • Serial (RS-232C) via DTC16 or DTC48 • Serial (RS-232C) via DTC16xx or DTC72MX 3-6 Host Computer Interface Installation and Configuration