HP d640 HP D640 High-Volume Printer - Installation Manual (Printer and Accesso - Page 57
Procedure 9: Adding New Supplies, Removing Plastic Protective Cover
View all HP d640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Procedure 9: Adding New Supplies 3. Open upper right cover. 4. Slowly and firmly lift up then pull down and out at an angle to remove plastic protec- tive cover. See Figure 2-46. NOTE: A small amount of toner may spill when this protector is removed. Remove slowly to avoid any spillage. If toner does spill, use the supplied cleaning cloths to clean it up. Clear plastic protector Upper right cover Figure 2-46 Removing Plastic Protective Cover 5. Turn Lever b1 counterclockwise to the SET position. 6. Close the front door. You are now ready to add the toner. 2-48 Installation
Procedure 9: Adding New Supplies
2-48
Installation
3.
Open upper right cover.
4.
Slowly and firmly lift up then pull down and out at an angle to remove plastic protec-
tive cover. See Figure 2-46.
NOTE: A small amount of toner may spill when this protector is removed.
Remove slowly to avoid any spillage. If toner does spill, use the supplied
cleaning cloths to clean it up.
Figure 2-46
Removing Plastic Protective Cover
5.
Turn Lever b1 counterclockwise to the SET position.
6.
Close the front door.
You are now ready to add the toner.
Clear plastic protector
..
..
....
.
.
.
.
.
.....
Upper right cover