Lantronix EMG 8500 EMG User Guide - Page 102

Figure 7-6 Network > Wireless Settings 7: Networking 2. Enter the following information: Wireless Mode Select the mode that WiFi should operate in. Wireless Client: If selected, enables the EMG to act as a wireless client of a WLAN network. In order to connect to a WLAN network, a WLAN profile for that network needs to exist and be enabled. The default is for the wireless client to be disabled Wireless Access Point: If selected, enables the access point to scan for wireless clients and allow them to connect and authenticate to the EMG. The default is for the access point to be enabled. The access point cannot be enabled if the wireless client is enabled. Disabled: If selected, disables the wireless client and the access point. 3. To save, select Apply. To configure the wireless client: 1. Enter the following information: WLAN Settings DHCP Acquired Gateway DHCP Acquired Primary/ Secondary DNS Select how an IP address is assigned to the wireless client: if Obtain from DHCP is selected, the EMG will acquire an IP address and subnet mask from the access point it connects to. If Specify is selected, the user can enter an IP address and subnet mask that is on the same subnet as the access point. (read only) Displays any gateway acquired from the access point the wireless client connects to. This gateway can be set as the default gateway for the EMG by configure the gateway precedence in the Network Port Settings. (read only) Displays any DNS servers acquired from the access point the wireless client connects to. EMG™ Edge Management Gateway User Guide 102