Lantronix EMG 8500 EMG User Guide - Page 69
Enter, Welcome to the Lantronix Edge Management Gateway
View all Lantronix EMG 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
5: Quick Setup Figure 5-5 Beginning of Quick Setup Script Welcome to the Lantronix Edge Management Gateway Model Number: EMG851000 Quick Setup will now step you through configuring a few basic settings. The current settings are shown in brackets ('[]'). You can accept the current setting for each question by pressing . 4. Enter the following information at the prompts: Note: To accept a default or to skip an entry that is not required, press Enter. CLI Quick Setup Settings Configure Eth1 IP Address (if specifying) Subnet Mask Default Gateway Hostname Domain Time Zone Description Select one of the following: (1) obtain IP Address from DHCP: The unit will acquire the IP address, subnet mask, hostname, and gateway from the DHCP server. (The DHCP server may or may not provide the gateway and hostname, depending on its setup.) This is the default setting. (2) obtain IP Address from BOOTP: Permits a network node to request configuration information from a BOOTP "server" node. (3) static IP Address: Allows you to assign a static IP address manually. The IP address is generally provided by the system administrator. An IP address that is unique and valid on your network and in the same subnet as your PC. There is no default. If you selected DHCP or BOOTP, this prompt does not display. Enter all IP addresses in dot-quad notation. Do not use leading zeros in the fields for dot-quad numbers less than 100. For example, if your IP address is 172.19.201.28, do not enter 028 for the last octet. Note: Configurations with the same IP subnet on multiple interfaces (Ethernet or PPP) are not currently supported. The subnet mask specifies the network segment on which the EMG resides. There is no default. If you selected DHCP or BOOTP, this prompt does not display. IP address of the router for this network. There is no default. The default host name is emgXXXX, where XXXX is the last 4 characters of the hardware address of Ethernet Port 1. There is a 64-character limit (contiguous characters, no spaces). Note: The host name becomes the prompt in the command line interface. If desired, specify a domain name (for example, support.lantronix.com). The domain name is used for host name resolution within the EMG unit. For example, if abcd is specified for the SMTP server, and mydomain.com is specified for the domain, if abcd cannot be resolved, the EMG attempts to resolve abcd.mydomain.com for the SMTP server. If the time zone displayed is incorrect, enter the correct time zone and press Enter. If the entry is not a valid time zone, the system guides you through selecting a time zone. A list of valid regions and countries displays. At the prompts, enter the correct region and country. EMG™ Edge Management Gateway User Guide 69