Lantronix EMG 8500 EMG User Guide - Page 70

5: Quick Setup CLI Quick Setup Settings Date/Time Sysadmin password Description If the date and time displayed are correct, type n and continue. If the date and time are incorrect, type y and enter the correct date and time in the formats shown at the prompts. Enter a new sysadmin password. Note: As a security measure, we recommend that you change the default sysadmin password initially and then change the password periodically. After you complete the Quick Setup script, the changes take effect immediately. Figure 5-6 Quick Setup Completed in CLI Welcome to the Lantronix Edge Management Gateway Model Number: EMG851000 Quick Setup will now step you through configuring a few basic settings. The current settings are shown in brackets ('[]'). You can accept the current setting for each question by pressing . ____Ethernet Port and Default Gateway The EMG851000 has two ethernet ports, Eth1 and Eth2. By default, both ports are configured for DHCP. Configure Eth1: (1) obtain IP Address from DHCP (2) obtain IP Address from BOOTP (3) static IP Address Enter 1-3: [1] The EMG851000 can be configured to use a default gateway. Enter gateway IP Address: [none] ____Hostname The current hostname is 'emgfcf0', and the current domain is ''. The hostname will be shown in the CLI prompt. Specify a hostname: [emgfcf0] Specify a domain: [] ____Time Zone The current time zone is 'GMT'. Enter time zone: [GMT] ____Date/Time The current time is Wed Jul 3 14:23:24 2019 Change the current time? [n] ____Sysadmin Password Enter new password: [] Quick Setup is now complete. EMG™ Edge Management Gateway User Guide 70