Lantronix EMG 8500 EMG User Guide - Page 110

7: Networking Channel Selection Security Suite Encryption Passphrase/Retype Passphrase IP Address Subnet Mask DHCP Pool Start/End IP Address Select the channel through which the access point will operate: Auto allows the radio to select a channel; or Manual allows the user to specify the channel on which the access point will operate. Select the authentication method for connecting to the access point: None for no security (not recommended), WPA for WiFi Protected Access, or WPA2 for WiFi Protected Access II security with AESCCMP encryption. When the Security Suite is set to WPA or WPA2, this selects the encryption used: CCMP for AES in Counter mode with CBC-MAC (preferred), TKIP for Temporal Key Integrity Protocol, or Any for both CCMP and TKIP. If WPA or WPA2 is selected for the Security Suite, enter the password to connect to the access point. Specifies the IP address of the access point. Specifies the network segment of the access point. The access point provides DHCP addresses to clients that connect to the access point. The DHCP Pool specifies the starting and ending IP address of the addresses (maximum of 5 clients can connect to the access point). These addresses must be in the same subnet as the IP address of the access point. 4. To save, select Apply. Active Client List This table shows the list of clients currently connected to the access point. Click on a MAC Address to view more information about the client. Interface Counters This table shows statistics for data received by and transferred from the access point. EMG™ Edge Management Gateway User Guide 110