Lantronix EMG 8500 EMG User Guide - Page 293

14: User Authentication User Rights The EMG has three user groups: Administrators, Power Users, and Default Users. Each has a predefined set of rights; users inherit rights from the user group to which they belong. These rights are in addition to the current functions that a user can perform at the command line interface:  connect direct/listen  set locallog/password/history/cli  show datetime/deviceport/locallog/portstatus/portcounters/  history/cli/user The table below shows the mapping of groups and user rights. Table 14-2 User Types and Rights User Right Full Administrative Rights Networking Services Date/Time Local Users Remote Authentication SSH Keys User Menus Device Port Operations Device Port Configuration USB Reboot/Shutdown Firmware/Configuration Diagnostics and Reports Secure Lantronix Network Web Access Internal Modem RPMs SD Card Administrator X X X X X X X X X X X X X X X X X X X Power Users Default Users X X X X X You cannot deny a user rights defined for the group, but you can add or remove all other rights at any time. By default, the system assigns new users to the Default Users group, but you can change their group membership at any time. If you change a user's rights while the user is logged into the web or CLI, the results do not take effect until the next time the user logs in. EMG™ Edge Management Gateway User Guide 293