Lantronix EMG 8500 EMG User Guide - Page 295

14: User Authentication Authenticate only Select the check box to authenticate users listed in the Remote Users list in the remote users who are lower part of the page. Disabled by default. in the remote users list Deny access to remote Select the check box to authenticate remote users whose LDAP group or users assigned to TACACS+ priv_lvl map to an EMG custom group, allow EMG access if matched. groups that do not map Disabled by default. to EMG custom group 2) Continue to set Local User Passwords: Complex Passwords Allow Reuse Reuse History Password Lifetime (days) Warning Period (days) Max Login Attempts Lockout Period (minutes) Select to enable the EMG unit to enforce rules concerning the password structure (e.g., alphanumeric requirements, number of characters, punctuation marks). Disabled by default. Complexity rules: Passwords must be at least eight characters long. They must contain one upper case letter (A-Z), one lower case letter (a-z), one digit ( 0-9), and one punctuation character Select to enable users to continue to reuse old passwords. If you disable the check box, they cannot use any of the Reuse History number of passwords. Enabled by default. The number of passwords the user must use before reusing an old password. The default is 4. For example, if you set reuse history to 4, the user may reuse an old password after using 4 other passwords. The number of days until the password expires. The default setting is 90. The number of days ahead that the system warns that the user's password will expire. The default setting is 7. The number of times (up to 8) the user can attempt to log in unsuccessfully before the system locks the user out. The default setting is 0 (disabled). The number of minutes (up to 90) the locked-out user must wait before trying to log in to the web interface again. The default setting is 0 (disabled). 2. Click the Apply button. Sysadmin Account Default Login Values On factory default EMG units, the local user sysadmin account has the following default login values. EMG units manufactured on or after January 1, 2020 and installed with firmware version 8.2.0.1 or later: username: sysadmin password: the last 8 characters of the Device ID. If the Device ID is not set, the password is the last 8 characters of the serial number. EMG units manufactured before January 1, 2020 and installed with firmware version 8.2.0.0: username: sysadmin password: PASS If you don't know when the EMG unit was manufactured, you can do the following to identify whether the device-unique sysadmin password is supported and enabled on the hardware. View EMG™ Edge Management Gateway User Guide 295