Lantronix EMG 8500 EMG User Guide - Page 230

10: Device Ports Dial-back Number Allow Dial-back Dial-back Delay Dial-back Retries Modem Timeout Restart Delay CBCP Server Allow No Callback Enable NAT The phone number to dial on callback for text or PPP dial-back connections. A site must successfully authenticate, have Allow Dial-back enabled and have a Dial-back Number defined in order for the site to be used for callback. If enabled, the site is allowed to be used for dial-back connections. For dial-back and CBCP Server, the number of seconds between the dial-in and dial-out portions of the dialing sequence. For dial-back and CBCP Server, the number of times the EMG unit will retry the dial-out portion of the dialing sequence if the first attempt to dial-out fails. Timeout for dial-in and dial-on-demand PPP connections. Select Yes (default) for the EMG to terminate the connection if no traffic is received during the configured idle time. Enter a value of from 1 to 9999 seconds. The default is 30 seconds. The number of seconds after the modem timeout and before the EMG unit attempts another connection. The default is 30 seconds. For a CBCP Server site, allows "No Callback" as an option in the CBCP handshake in addition to User-defined Number and Admin-defined Number. Select to enable Network Address Translation (NAT) for PPP connections. Note: IP forwarding must be enabled on Network Port Settings (on page 80) for NAT to work. 3. Click the Add Site button. To view or update a site: 1. In the Sites table, select the site and click the View Site button. The site attributes are displayed in the bottom half of the page. 2. Update any of the site attributes. 3. Click the Edit Site button. To delete a site: 1. Select the site in the Sites table. 2. Click the Delete Site button. Site Commands Go to Site Commands to view CLI commands which correspond to the web page entries described above. EMG™ Edge Management Gateway User Guide 230