Lantronix EMG 8500 EMG User Guide - Page 229
Reset Site, Negotiate IP Address
View all Lantronix EMG 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
10: Device Ports Note: To clear fields in the lower part of the page, click the Reset Site button. Site Id (view only) Site Name Port Login/CHAP Host CHAP Secret/Retype Authentication Timeout Logins Negotiate IP Address Static Route IP Address Static Route Subnet Mask Static Route Gateway Dial-out Number Dial-out Login Dial-out Password Retype Password Displays after a site is created. Enter a name for the site. Select the port: None, Internal Modem, Device Port, or USB Port U1 the site is assigned to. For dial-on-demand sites, a port must be selected. For any other sites, the port selection can be set to None. See Modem Dialing States on page 231. The login name (for PAP authentication) or CHAP host (for CHAP authentication) associated with this site. If a modem has sites enabled and the authentication is successful at dial-in (for modem states dial-in, dial-back, CBCP server, dial-in & dial-on-demand, or dial-back & dial-on-demand), and the name that was authenticated matches the Login/CHAP Host, the site parameters will be used for the remainder of the modem connection. The CHAP secret associated with this site. If a modem has sites enabled and CHAP authentication enabled, then at dial-in, if the remote server sends a name in the CHAP challenge response that matches the CHAP host of a site, the CHAP secret for the site will be used to authenticate the CHAP challenge response sent by the remote server. The type of authentication, PAP or CHAP, for which this site is applicable. On dial-in authentication, only sites with the authentication type that matches the authentication type configured for the modem will be used to try to find a matching site. For text dial-in connections, the connection can time out after the connection is inactive for a specified number of minutes. If the EMG and the remote server should negotiate the IP addresses for each side of the PPP connection, select Yes. Select No if the address of the EMG unit (Local IP) and remote server (Remote IP) need to be specified. The Static Route IP Address, Subnet Mask and Gateway must be configured for dial-on-demand sites. The EMG will automatically dial-out and establish a PPP connection when IP traffic destined for the network specified by the static route needs to be sent. Note: Static Routing must be enabled on the Network - Routing page for dial-ondemand connections. The subnet mask for a dial-on-demand connection. The gateway for a dial-on-demand connection. The dial-out number must be specified for dial-on-demand sites. This indicates the phone number to dial when the EMG unit needs to send IP traffic for a dial-ondemand connection. User ID for authentication when dialing out to a remote system, or when a remote system requests authentication from the EMG unit when it dials in. May have up to 32 characters. This ID is used for authenticating the EMG during the dial-out portion of a dial-back (including CBCP server) and dial-on-demand. Password for authentication when dialing out to a remote system, or if a remote system requests authentication from the EMG unit when it dials in. May have up to 64 characters Re-enter password for dialing out to a remote system. May have up to 64 characters. EMG™ Edge Management Gateway User Guide 229