Lantronix EMG 8500 EMG User Guide - Page 220

10: Device Ports State Normal State (view only) Displays the current state of the port: on or off. Defines the typical or normal state of the DIO Input port. This setting is used for Events. 2. Change the following Front Relay port fields: Name State Normal State Wake State Latch The name of the port. Valid characters are letters, numbers, dashes (-), periods and underscores ( _ ). (view only) Displays the current state of the port: on or off. The Change State check box and Off / On selection can be used to change the state of the port. Defines the typical or normal state of the Relay port. This setting is used for Events. The initial state of the relay port when the EMG boots. Controls how a relay will be turned off if it is turned on as the result of an event trigger. If Latch is enabled, the user will need to explicitly turn off the relay when it is turned on as a result of an event. If Latch is disabled, the relay will automatically turn off after the trigger condition corrects itself and is no longer active. 3. To save, click Apply. See Events on page 359 for information on configuring events for the DIO ports. DIO Commands Go to DIO Commands to view CLI commands which correspond to the web page entries described above. EMG™ Edge Management Gateway User Guide 220