Lantronix EMG 8500 EMG User Guide - Page 83

7: Networking Figure 7-3 Network Settings > SFP NIC Information & Diagnostics 2. Enter the following information: Ethernet Interfaces (Eth1 and Eth2) Note: Configurations with the same IP subnet on multiple interfaces (Ethernet or PPP) are not currently supported. Eth1 Settings or Eth2 Settings IP Address (if specifying) Subnet Mask  Disabled: If selected, disables the network port.  Obtain from DHCP: Acquires IP address, subnet mask, hostname and gateway from the DHCP server. (The DHCP server may not provide the hostname gateway, depending on its setup.) This is the default setting. If you select this option, skip to Gateway.  Obtain from BOOTP: Lets a network node request configuration information from a BOOTP "server" node. If you select this option, skip to Gateway.  Specify: Lets you manually assign a static IP address, generally provided by the system administrator.  Enter an IP address that will be unique and valid on your network. There is no default.  Enter all IP addresses in dot-quad notation. Do not use leading zeros in the fields for dot-quad numbers less than 100. For example, if your IP address is 172.19.201.28, do not enter 028 for the last segment octet. Note: Currently, the EMG unit does not support configurations with the same IP subnet on multiple interfaces (Ethernet or PPP). If specifying an IP address, enter the network segment on which the EMG unit resides. There is no default. EMG™ Edge Management Gateway User Guide 83