Lantronix EMG 8500 EMG User Guide - Page 47
Connecting Terminals, Warning, To connect a terminal
View all Lantronix EMG 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
3: EMG 8500 Installation Warning: The EMG must be powered off when installing or replacing the modules. Not powering off the device before changing the module will void the manufacturer warranty. Figure 3-10 Sample Connectivity Module Configuration (Back Side) Web Manager Dashboard Bay 1(empty) Bay 2 Ethernet/SFP Connecting Terminals The console port is for local access to the EMG and the attached devices. You may attach a dumb terminal or a computer with terminal emulation to the console port. The EMG console port uses RS-232C protocol and supports VT100 emulation. The default serial settings are: 9600 baud 8 bit data No parity 1 stop bit No flow control To connect the console port to a terminal or computer with terminal emulation, Lantronix offers optional adapters that provide a connection between an RJ45 jack and a DB9 or DB25 connector. The console port is configured as DTE (non-reversed RJ45). See Appendix C: Adapters and Pinouts for more information. To connect a terminal: 1. Attach the Lantronix adapter to your terminal (typically a PN 200.2066A adapter - see Figure C-1) or your PC's serial port (use PN 200.2070A adapter - see Figure C-4). 2. Connect the Cat 5 cable to the adapter, and connect the other end to the EMG console port. 3. Turn on the terminal or start your computer's communication program (e.g., PuTTY or TeraTerm Pro). 4. Once the EMG is running, press Enter to establish connection. You should see the model name and a login prompt on your terminal. 5. Log in with the default user name sysadmin and the last 8 characters of the Device ID (for newly manufactured units that come installed with 8.2.0.1 or later) or PASS (for all older units) as the password. EMG™ Edge Management Gateway User Guide 47