Lantronix EMG 8500 EMG User Guide - Page 38
Order Information, User Supplied Items, Customize an EMG, EMG 8500 Installation
View all Lantronix EMG 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
3: EMG 8500 Installation Order Information To view order information, part numbers and extended support options, go to https:// www.lantronix.com/products/lantronix-emg/#tab-order-now. User Supplied Items To complete your installation you will need the following items: Medium size Phillips screwdriver to install the mounting brackets to the EMG unit, if applicable One or more serial devices that require network connectivity A serial cable for each serial device. - For RJ45 ports, you may use a straight-through RJ45 patch cable to connect to Cisco and Sun RJ45 serial console ports. - For USB ports, use a cable with a USB Type A connector - For information about Lantronix adapters, see Appendix C: Adapters and Pinouts. An available connection to your Ethernet network and an Ethernet cable CAT5E or better cables are recommended for 1000 Base Ethernet. A working AC power outlet to power the unit using the included AC (90W, 100-240V, 50/60 Hz) power supply. If the LTE cellular modem is installed, a network SIM card (and data services) from a service provider Customize an EMG Build any combination up to 8 managed console ports and up to two connectivity modules by following these steps: 1. Pick a baseline configuration: I/O: 4 port RS-232 or 4 port USB or two 4 port RS-232 modules Connectivity module: Zero or one cellular module 2. Add up to one I/O module and up to two connectivity modules: I/O: 4 port RS-232 or 4 port USB Connectivity module: cellular module, Wi-Fi module, or dialup modem 3. Protect the investment with various extended warranty and service options. Go to https:// www.lantronix.com/products/lantronix-emg/#tab-order-now to purchase extended support. EMG™ Edge Management Gateway User Guide 38