Lantronix EMG 8500 EMG User Guide - Page 33

2: Introduction The EMG unit will recognize two network connections. One connection must be either Eth1 or SFP1. The second connection must be either Eth2 or SFP2. If a single mode and a multi-mode SFP module are both installed on the EMG unit, the device can be configured to utilize one mode at a time. One possible use for the two Ethernet ports is to have one port on a private, secure network and the other on a public, unsecured network. Ethernet and SFP LEDs The Ethernet ports and the SFP ports contain LEDs. The LED indicators are the following:  Green LED - indicates link status  Yellow LED - indicates activity status Figure 2-11 EMG 8500 Dual SFP Connection LTE Cellular The EMG 8500 is equipped with two user swappable connectivity slots on the back of the unit. One LTE/4G cellular modem may be installed. See Connectivity Module Installation on page 50. The EMG 7500 is offered with the option of an internal LTE cellular modem. The LTE cellular modem module supports one main antenna, one AUX antenna, and one GNSS antenna for geolocation. (The geolocation function is not active in the current release). The LTE cellular modem module supports one micro SIM card, provided by the local subscribed Internet service provider (ISP). On the EMG 8500, the micro SIM card slot is located on the inside of the cellular modem module, as shown in Figure 2-12. The EMG 8500 unit must be powered off before installing or replacing the micro SIM card. On the EMG 7500, the micro SIM slot is located on the back of the unit, as shown in Figure 2-7. The EMG 7500 does not have to be powered off before inserting or replacing the micro SIM card. EMG™ Edge Management Gateway User Guide 33