Lantronix EMG 8500 EMG User Guide - Page 289

13: Connections Port If the to field is set to Device Port or Modem on Device Port, enter the number of the device port. For all other options, this is the TCP/UDP port number, which is optional for Telnet out and SSH out, but required for TCP Port and UDP Port. Note: If you select Device Port, it must not have command line interface logins enabled or be running a loopback test. To view the device port's settings, click the Settings link to the right of the port number. SSH Out Options Select one of the following optional flags to use for the SSH connection.  User: Login ID to use for authenticating on the remote host.  Version: Version of SSH. Select 1 or 2.  Command: Enter a specific command on the remote host (for example, reboot). Trigger Select the condition that will trigger a connection. Options include:  Connect now: Connects immediately, or if you reboot the EMG, immediately on reboot.  Connect at date/time: Connects at a specified date and time. Use the drop-down lists to complete the date and time. Upon rebooting, the EMG unit reestablishes the connection if the date/time has passed.  Auto-connect on characters transferring: Select the arrow indicating the direction of the data transfer and either the minimum number of characters or a specific character sequence that will trigger the connection. You can select the direction of the data transfer only if Data Flow is bidirectional. Upon rebooting, the EMG does not reestablish the connection until the specified data has passed through one of the endpoints of the connection. 3. To save, click the Apply button. To view, update, or disconnect a current connection: The bottom of the Devices > Connections page displays current connections. Figure 13-7 Current Connections 1. To view details about a connection, hold the mouse over the arrow in the Flow column. 2. To disconnect (delete) a connection, select the connection in the Select column and click the Terminate button. 3. To reestablish the connection, create the connection again in the top part of the page. 4. To view information about Web connections, click the here link in the text above the table. The Maintenance > Firmware & Configurations page displays. Connection Commands Go to Connection Commands to view CLI commands which correspond to the web page entries described above. EMG™ Edge Management Gateway User Guide 289