Lantronix EMG 8500 EMG User Guide - Page 45

3: EMG 8500 Installation To connect to a USB device port: 1. Connect the USB type A connector of a USB cable to a device port. 2. Connect the other end of the USB cable to a USB console port. Figure 3-8 shows a sample I/O module installation with one 4-port USB I/O module in Bay 1 and one 4-port RJ45 I/O module in Bay 2, and how the device ports correspond to the buttons on the Web Manager Dashboard. Figure 3-8 Sample Device Port Connections (Front Side) Dashboard Bay 1 4-Port USB I/O Module Bay 2 4-Port RJ45 I/O Module Modular Expansion for I/O Module Bays The EMG module configuration can be changed by adding or replacing I/O modules in the I/O module bays. When populating the bays, Bay 1 and Bay 2 may be populated in any order and one module may be left empty. The bays are ordered from left to right: Bay 1 is the slot next to the console port and USB port and Bay 2 is the slot to the right of Bay 1. See Figure 3-8. Any changes to the I/O modules must be done while the EMG unit is powered off. Table 3-9 shows the available I/O module configurations. To install an I/O module, refer to I/O Module Installation on page 49. Warning: Install the I/O module on the front only of the EMG unit. Do not insert any other module on the front of the EMG unit. Doing so may damage the EMG unit and will void the manufacturer warranty. EMG™ Edge Management Gateway User Guide 45