Lantronix EMG 8500 EMG User Guide - Page 112

7: Networking To map a ruleset to a network interface: 1. Click the Network tab and select the IP Filter option. The Network > IP Filter page displays. 2. Select the IP filter rule set to be mapped. 3. From the Interface drop-down list, select the desired network interface and click the Map Ruleset button. The Interface and rule set display in the IP Filter Mappings table. To delete a mapping: 1. Click the Network tab and select the IP Filter option. The Network > IP Filter page displays. 2. Select the mapping from the list and click the Delete Mappings button. The mapping no longer displays. 3. Click the Apply button. Enabling IP Filters On the Network > IP Filter page, you can enable all filters or disable all filters. Note: There is no way to enable or disable individual filters. To enable IP filters: 1. Enter the following: Enable IP Filter Packets Dropped Packets Rejected Test Timer Time Remaining Select the Enable IP Filter checkbox to enable all filters, or clear the checkbox to disable all filters. Disabled by default. Displays the number of data packets that the filter ignored (did not respond to). View only. Displays the number of data packets that the filter sent a "rejected" response to. View only. Timer for testing IP Filter rulesets. Select No to disable the timer. Select Yes, minutes (1-120) to enable the timer and enter the number of minutes the timer should run. The timer automatically disables the IP Filters when the time expires. Indicates how many minutes are left on the timer before it expires and IP Filters disabled. View only. EMG™ Edge Management Gateway User Guide 112