Lantronix EMG 8500 EMG User Guide - Page 96
Cellular Modem Commands
View all Lantronix EMG 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 96 highlights
7: Networking System mode: current cellular mode, such as LTE PS state: the packet service attach status LTE band: current band being used by the modem LTE bw: current band frequency LTE Rx chan: receive channel in use LTE Tx chan: transfer channel in use LTE CA state: carrier aggregation assignment EMM state: EPS Mobility Management state RRC state: Radio Resource Control state IMS reg state: IP Multimedia Subsystem state PCC RxM RSSI / RSRP (dBm): Main antenna Received Signal String Indicator and Reference Signal Received Power level PCC RxD RSSI / RSRP (dBm): Secondary antenna Received Signal String Indicator and Reference Signal Received Power level Tx Power: Transmit power TAC: Tracking Area Code RSRQ (dB) / Cell ID: Reference Signal Received Quality and cellular identifier SINR (dB): Signal to Interference & Noise Ratio Uptime: the same value shown in Current Time in different format SIM lock status: the current SIM lock status on the cellular modem Network Operator: the carrier configured on the cellular modem Network Auth Mode: the authentication mode (PAP, CHAP or none) configured on the cellular modem Roaming: the roaming state configured on the cellular modem FW 1 / FW 2 / FW 3 / FW 4 / Max FW images / Active FW image: the firmware images that are loaded in the modem and which firmware slot is being used PRI FF: the carrier firmware images that are loaded in the modem Current & Preferred Images: the preferred and current firmware and carrier images Cellular Modem Commands Go to Cellular Modem Commands to view CLI commands which correspond to the web page entries described above. EMG™ Edge Management Gateway User Guide 96