Lantronix EMG 8500 EMG User Guide - Page 225
Clear Host Parameters, Add Host List, Protocol, Escape Sequence
View all Lantronix EMG 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 225 highlights
10: Device Ports Protocol Port Escape Sequence Protocol for connecting to the host (TCP, SSH, or Telnet). Port on the host to connect to. The escape character used to get the attention of the SSH or Telnet client. It is optional, and if not specified, Telnet and SSH use their default escape character. For Telnet, the escape character is either a single character or a two-character sequence consisting of '^' followed by one character. If the second character is '?', the DEL character is selected. Otherwise, the second character is converted to a control character and used as the escape character. For SSH, the escape character is a single character. Note: When the Device Port Esc Sequence/ViewLog/PowerMenu Escape Sequence is configured, the following escape sequence precedent behavior can be expected: 1) Escape 2) PowerMenu 3) ViewLogs A clear/restart of the remaining escape events occurs when there is a match in any configured sequence. All the sequences should have unique sequence defined and user should avoid overlapping sequence strings. When detecting key sequences, after receiving the first character(s) of a sequence, the EMG will wait 3 or more seconds for the remaining characters, before timing out and sending all characters to the device. For example, if the Escape Sequence is ABCD, and the user types "AB", the EMG will wait at least 3 seconds for the next character ("C") before timing out and sending the "AB" characters to the device. 4. Click the right arrow to add the host. The host displays in the Hosts box. 5. Repeat steps 3-4 to add more hosts to the host list. 6. Click the Clear Host Parameters button to clear fields before adding the next host. 7. You have the following options: - To remove a host from the host list, select the host in the Hosts box and click the left arrow. - To give the host a higher precedence, select the host in the Hosts box and click the up arrow. - To give the host a lower precedence, select the host in the Hosts box and click the down arrow. 8. Click the Add Host List button. After the process completes, a confirmation message is displayed on the page. EMG™ Edge Management Gateway User Guide 225