Lantronix EMG 8500 EMG User Guide - Page 302
connect direct, connect, direct, connect listen, set locallog clear, Authentication Methods
View all Lantronix EMG 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 302 highlights
14: User Authentication 2. Enter the following: Enable NIS Displays selected if you enabled this method on the Authentication Methods page. If you want to set up this authentication method but not enable it immediately, clear the checkbox. Note: You can enable NIS here or on the first User Authentication page. If you enable NIS here, it automatically displays at the end of the order of precedence on the User Authentication page. NIS Domain The NIS domain of the EMG must be the same as the NIS domain of the NIS server. Broadcast for NIS Server If selected, the EMG unit sends a broadcast datagram to find the NIS Server on the local network. NIS Master Server The IP address or host name of the master server. NIS Slave Servers #1 -5 The IP addresses or host names of up to five slave servers. Custom Menu If custom menus have been created you can assign a default custom menu to NIS users. Escape Sequence A single character or a two-character sequence that causes the EMG to leave direct (interactive) mode. (To leave listen mode, press any key.) A suggested value is Esc+A (escape key, then uppercase "A" performed quickly but not simultaneously). You would specify this value as \x1bA, which is hexadecimal (\x) character 27 (1B) followed by an A. This setting allows the user to terminate the connect direct command on the command line interface when the endpoint of the command is deviceport, tcp, or udp. See Key Sequences on page 235 for notes on key sequence precedence and behavior. Break Sequence A series of 1-10 characters users can enter on the command line interface to send a break signal to the external device. A suggested value is Esc+B (escape key, then uppercase "B" performed quickly but not simultaneously). You would specify this value as \x1bB, which is hexadecimal (\x) character 27 (1B) followed by a B. Enable for Dial-back Select to grant a user Dial-back (on page 231). Users with dial-back access can dial into the EMG and enter their login and password. Once the EMG unit authenticates them, the modem hangs up and dials them back. Disabled by default. Dial-back Number The phone number the modem dials back on depends on this setting for the device port. The user is either dialed back on a fixed number, or on a number that is associated with the user's login (specified here). Data Ports The ports users are able to monitor and interact with using the connect direct command. Enter the port numbers or the range of port numbers (for example, 1, 5, 8, 10-15). U1 denotes the USB port on the front of the EMG unit. Listen Ports The ports users are able to monitor using the connect listen command. Clear Port Buffers The ports whose port buffer users may clear using the set locallog clear command. EMG™ Edge Management Gateway User Guide 302