Lantronix EMG 8500 EMG User Guide - Page 246

11: Remote Power Managers RPMs - Outlets The Outlets page allows the administrator to view the current status of each individual outlet on an RPM, and change the state of the outlets. Not all RPMs support individual outlet status and control. To control and view status for RPM outlets: 1. Click the Devices tab and select the RPMs option. Figure 11-1 Devices > RPMs shows the page which displays. 2. Select an RPM and click the Outlets link. Figure 11-9 RPMs - Outlets shows the page which displays. This page will, at a minimum, list the outlet numbers and their state - On or Off. If the RPM provides additional information for the outlets, the custom name and the current reading in Amperes will also be displayed for each outlet. Figure 11-9 RPMs - Outlets 3. To change the state of one or more outlets, select the outlets, and click the Cycle Power, Turn On or Turn Off buttons. The command will be sent to the RPM and the page will refresh. It may take one or two minutes before the new outlet state(s) are reflected on the Outlets page. RPM Shutdown Procedure This section applies to UPS-type RPMs only, and does not apply to PDU-type RPMS. This section describes the shutdown process when a UPS managed by the EMG reaches a low battery state. When one UPS reaches a low battery state, the EMG can be configured to allow the UPS to EMG™ Edge Management Gateway User Guide 246