Lantronix EMG 8500 EMG User Guide - Page 211

Byte Threshold Token Actions Email to Email Subject String to Send Power Supply Power Action Action Delay Restart Delay 10: Device Ports The number of bytes of data the port will receive before the EMG unit will capture log data and initiate the selected actions. The default is 100 bytes. In most cases, the console port of your device does not send any data unless there is an alarm condition. After the EMG unit receives a small number of bytes, it perceives that your device needs some attention. A threshold set to 30 characters means that as soon as the unit receives 30 bytes of data, it performs the actions that are selected for this port. The specific pattern of characters the EMG unit must recognize before initiating the actions configured for this port. The maximum is 100 characters. You may use a regular expression to define the pattern. For example, the regular expression "abc[def]g" recognizes the strings abcdg, abceg, abcfg. The EMG supports GNU regular expressions. For more information see:  http://www.gnu.org/software/libc/manual/html_node/Regular-Expressions.html  http://www.delorie.com/gnu/docs/regex/regex.html Select one or more actions to perform if there is a data trigger:  Syslog: A message is logged to the system log indicating what the data trigger was along with the initial portion of the data received.  SNMP Trap: A slcEventDevicePortData trap will be sent to the NMS configured in the SNMP settings.  Email: An email alert will be sent to the address configured for the device port.  Send String to Device: A string will be sent to the device connected to the device port.  Control Power Supply: The state of one or more of the device port power supplies can be changed. The email address of the message recipient(s) for an email alert. To enter more than one email address, separate the addresses with a single space. You can enter a total of 128 characters. A subject text appropriate for your site. May have up to 128 characters. The email subject line is pre-defined for each port with its port number. You can use the email subject to inform the desired recipients of the problem on a certain server or location (e.g., server location or other classification of your equipment). Note: The character sequence %d anywhere in the email subject is automatically replaced with the device port number. The string to send to the device connected to the device port. The string supports the following special characters: newline ("\n"), double quote ("\""), single quote ("\'"), and escape ("\x1b"). You can enter a total of 128 characters. The power supply that provides power to the device connected to the device port which to control. Select either all power supplies or an individual power supply. The action to perform on the selected power supply or power supplies - Cycle Power, Turn On or Turn Off. A time limit of how long, in seconds, the device port will capture data after the data trigger is detected and before closing the log file (with a fixed internal buffer maximum capacity of 1500 bytes) and performing the selected actions. The default is 60 seconds. The number of seconds for the period of time, after performing the selected action, during which the device port will ignore additional characters received. The data will simply be ignored and not trigger additional actions until this time elapses. The default is 60 seconds. EMG™ Edge Management Gateway User Guide 211