Netgear R6250 User Manual - Page 92
Wireless Access Point (AP
View all Netgear R6250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
R6250 Smart WiFi Router Wireless Access Point (AP) You can set up the router to run as an access point (AP) on the same local network as another router. To set up the router as an AP: 1. Use an Ethernet cable to connect the Internet port of this router to a LAN port in the other router. Cable this port to a LAN port on the other router 2. Select Advanced > Advanced Setup > Wireless Settings. 3. Select the Enable Access Point Mode check box. The AP Mode section of the screen expands. 4. Select the check box for the IP address setting that you want to use: • Get an IP address dynamically from the other router. The other router on the network assigns an IP address to this router while this router is in AP mode. • Fixed IP address (not recommended). Use this setting if you want to manually assign a specific IP address to this router while it is in AP mode. Using this option effectively requires advanced network experience. Advanced Settings 92